Mounting & Placement

 

Let's get this party started!

Your mount package comes complete with Wall Plugs, Stainless Steel Screws, and Standoff Sets. For a flawless setup, we recommend using a 6.5mm drill bit.

Here's how to mount your products like a pro:

→ Position your new Holidae product where you would like it to hang, make sure it's level, and mark the centre of the holes onto the surface using a pencil.

→ Drill holes on these marks, then push each wall anchor into its hole until it is flush with the wall.

→ Thread the Screw through the Standoff Barrel and screw into the wall anchor/wall using a 6mm drill bit. Do this for all Stand Off Barrels.

→ Lay the sign on top of the barrels and line up the holes. Make sure you have a washer and a packer sandwiched between the Stand Off Barrel and the back of the sign.

→ Thread the second washer through the Standoff Screw and secure the Standoff Cap to the Standoff Barrel, so the sign is sandwiched between the two.

For CPR signs, placement is important: 

→ Attach the sign on a suitable wall inside the pool area (like a cabana, outdoor shower, etc) where it can’t become a foothold.

→ Check that you can read the CPR instructions from any spot within the pool area.

→ Think about putting your CPR sign closest to where you might retrieve a person from a pool to perform CPR. The sign may be best placed near the shallow end of the pool or near the steps.